—27—
Heater grounding wire (Green)
Circuit grounding wire (Black)
2
Remove terminal block cover clamping screw.
(one PTT screw 4 x 8, indicated by
O
)
3
Remove grounding wire clamping screws.
(two PTT screws with toothed washer 4 x 8 (BS), indicated by
)
4
Remove clamping screws for the control circuit board, cord
holder and ferrite core.
(five PTT screws 4 x 16, indicated by
Q
)
5
Remove the cord band. (indicated by
)
6
Taking out the control circuit board, remove the circuit board
cover. (indicated by
O
)
7
Disconnect lead wires from the control circuit board, and
remove the cord bushings. (indicated by
O
)
Cautions for assembly
• Remove the terminal block cover before the control circuit
board.
• Do not omit to use toothed washers when installing the
grounding wires.
Cautions for assembly
• Connect lead wires referring to the printing on the control
circuit board.
• Use the cord bushing of smaller hole diameter at the upper
part in the photograph.
(4) Control circuit board
1
Pull out the drain tank and remove front panel clamping screws.
(two special screws 4 x 16, indicated by
O
)
Содержание JT-SB116EH-W-CA
