Mitsubishi Electric JT-SB116EH-W-CA, Руководство пользователя

Страница: 4 / 46

—4—
2. Features
1 Quick drying
Equipped with a turbo fan, the hand dryer blows away drops of water on the hands with a high-speed jet
air from a large wind volume, high-speed blower, thus quickly drying hands.
Drying time has been reduced considerably compared with old model (JT-SB216DS).
2 Reduction of operating sound by 6dB
Employment of a hyper-nozzle, based on our own blast flow control technology, which eliminates
turbulences as well as interfering sounds of air flows, has reduced the operating sound by 6 dB.
3 Wind volume adjust knob
Wind volume can be changed, as you like, with this knob.
4 Ergonomic design
The product is finished up in an ergonomic design that fuses sharp lines well matched with the sanitary
space and round lines for convenience of use.
5 Hygienic
• The hand dryer is automatically started by a sensor. Thus, there is no need to touch the hand dryer with
your wet hands. It is very hygienic.
• It has a flat bottom at the hand inserting area and also the sides are widely open so that the unit can be
cleaned easily.
• Hand inserting sections can be disinfected with alcohol to keep them hygienic. Use the disinfecting
ethanol (Concentration less than 83%).
6 Antibacterial
• The hand dryer uses a silver inorganic substance; thus, maintaining an antibacterial effect for an
extended period of time. (Hand inserting area, drain hose and drain tank)
• The hand dryer meets the antibacterial effect standard defined by the Society of Industrial Technology for
Antimicrobial Articles (SIAA).
7
Easy maintenance
The hand dryer does not require a paper or cloth towel, thus eliminating the dumping paper waste and the
exchanging of towels. Also, the hand dryer is easy to clean.
8
Highly safe with mischievous use prevention timer
To prevent continuous operations of the hand dryer by mischievous use or malfunction, it has a built-in
timer that automatically stops drying upon reaching a specific period of time.
O Upon completing repair work, verify that the product operates normally. Clean the product's main body and
surrounding area, and notify the customer of the completion of the repair work.
Items to check during repair work
• Inspect the condition of the earth. Correct it if improperly grounded. Also, check to see if a ground fault circuit
interrupter is being installed. If not, install one.
• Check to see whether or not the air filter and the drain tank are installed securely in place.
• Do not leave a towel or other object in the hand-drying area.
• Never place any object on the main body nor cover it.
• Make sure that the product is not being used in any of the following locations:
Locations where the temperature can exceed 0°C to 40°C.
Locations where the humidity can exceed 5%RH to 95%RH.
Locations where the unit may come into direct contact with water.
Locations where the unit is under direct or strong sunlight. (May cause sensor to malfunction.)
Locations where there is a lot of condensation.
Vehicles (incl. vessels, trains.)
Do not use in locations where corrosive, neutral, or reductive gases are present.
Avoid to install the unit any place where foods, tableware, or the likes are handled nearby because water
may splash.
Locations where solt damage may occur.
Places lower than -20m or higher than 2000m above sea level.