Mitsubishi Electric HG-KN, Инструкция по эксплуатации

Страница: 91 / 104

APPENDIX
App. - 2
App. 3 Compliance with the CE marking
App. 3.1 What is CE marking?
The CE marking is mandatory and must be affixed to specific products placed on the European Union. When
a product conforms to the requirements, the CE marking must be affixed to the product. The CE marking
also applies to machines and equipment incorporating servos.
A manual is available in different languages. For details, contact your local sales office.
(1) EMC directive
The EMC directive applies to the servo motor alone. Therefore servo motor is designed to comply with
the EMC directive. The EMC directive also applies to machines and equipment incorporating servo
motors. HG-KN and HG-SN series comply with EN61800-3 Category 3. They are not intended to be
used on a low-voltage public network which supplies domestic premises; radio frequency interference is
expected if it is used on such a network. The installer shall provide a guide for installation and use,
including recommended mitigation devices.
(2) Low voltage directive
The low voltage directive also applies to the servo motor alone. The servo motor is designed to comply
with the low voltage directive.
(3) Machinery directive
The servo motor as a single unit does not comply with the Machinery directive due to correspondence
with article1 2. (k). However, the Machinery directive applies to machines and equipment incorporating
servo motors. Please check your machines and equipment as a whole if they are complied.
App. 3.2 For compliance
Be sure to perform an appearance inspection of every unit before installation. In addition, have a final
performance inspection on the entire machine/system, and keep the inspection record.
(1) Wiring
Use wiring which comply with EN for the servo motor power. Products in compliance with EN are
available as options.
(2) Performing EMC tests
When EMC tests are run on a machine and device into which the servo motor and servo motor have
been installed, it must conform to the electromagnetic compatibility (immunity/emission) standards after
it has satisfied the operating environment and electrical equipment specifications.
For EMC directive conforming methods about servo amplifiers and servo motors, refer to "EMC
Installation Guidelines" and each servo amplifier instruction manual.