19
GB
[1]
Supplied parts
This unit includes the following parts.
1
Band ··· 2 pcs.
[2]
Preparation for installation
&KHFNWKDWWKHPDLQSRZHURQWKHRXWGRRUXQLWLVWXUQHGRII
$IWHUWXUQLQJRIIWKHPDLQSRZHUOHDYHLWWXUQHGRIIIRUDWOHDVWPLQXWHVEHIRUHSURFHHGLQJWKHLQVWDOODWLRQZRUN
[3]
Installation
(1) Thread the power source cable through the rubber bushing on the left side. (Refer to Fig. 1, Note 1, and Note 2.)
(2) Thread the unit wiring (sensor wiring) and the transmission cable through the rubber bushing on the right side. (Refer to Fig. 1, Note 1, and Note 2.)
(3) Hold the power source cable and the transmission cable in place respectively with the cable straps. (Refer to Fig. 1)
(4) Connect the cables respectively to the power supply terminal block and the terminal block for transmission line. (Refer to Fig. 1)
(5) Secure each rubber bushing with the supplied band. (Refer to Fig. 1 and Note 3)
Cable strap
Rubber bushing
Tie band
(Supplied)
Transmission
terminal block
Cable strap
Tie band
(Supplied)
Rubber bushing
Unit wiring
(sensor wiring)
Transmission cable
(not supplied)
Power cable
(not supplied)
<Fig. 1>
Unit wiring
(Trans)
Note 1) Make sure the cables are not coming out of the rubber bushing cut. (Fig. 2 and Fig. 3)
Cut
Top view
Wiring
Rubber bushing
Wiring
Rubber bushing
(oval part)
Rubber bushing
(oval part)
Wiring
Cables are coming out of the rubber bushing.
Top view
Cross-sectional view
<Fig. 2>
<Fig. 3>
Note 2) When threading the wiring through the rubber bushing, make sure the rubber bushing will not come off the sheet metal on the control box guard.
(Fig. 4 and Fig. 5)
Rubber bushing
Sheet metal
on the guard
Sheet metal
on the guard
Rubber bushing
<Fig. 4>
<Fig. 5>
Note 3) When tying the supplied band around the rubber bushing, make sure to leave no gap between the ends. (Fig. 6 and Fig. 7)
<<Important>>
When putting the band on the rubber
bushing, make sure the ends of the
rubber bushing overlap each other as
shown in Fig. 6.
* If there is a gap, water from snow
or rain may enter, resulting in
equipment damage.
Approx. 20 mm [13/16 in]
Band
Overlapped
rubber bushing
Cut on the
rubber bushing
<Fig. 6: Back of the rubber bushing>
Cut on
the rubber
bushing
There is a gap
in the rubber
bushing.
<Fig. 7: Back of the rubber bushing>
M-NET
board
Power supply terminal block
