Mitsubishi Electric City Multi PFAV-P500VMH-E, Руководство по обслуживанию

Страница: 122 / 242

[
X
Troubleshooting ]
- 113 -
HWE07150 GB
1. Error Code
Open phase
2. Error definition and error detection method
ΠAn open phase of the power supply (L1 phase, N phase) was detected at power on.
ΠThe L3 phase current is outside of the specified range.
The open phase of the power supply may not always be detected if a power voltage from another circuit is applied.
3. Cause, check method and remedy
4102
Cause Check method and remedy
(1) Power supply problem
ΠOpen phase voltage of the power supply
ΠPower supply voltage drop
Check the input voltage to the power supply terminal block TB1.
(2) Noise filter problem
ΠCoil problem
ΠCircuit board failure
ΠCheck the coil connections.
ΠCheck for coil burnout.
ΠConfirm that the voltage at the CN3 connector is 198 V or
above.
(3) Wiring failure Confirm that the voltage at the control board connector CNAC is
198 V or above.
If the voltage is below 198V, check the wiring connection between
the noise filter board CN3, noise filter board CN2 and control
board CNAC.
Confirm that the wiring between noise filter TB23 and INV board
SC-L3 is put through CT3.
(4) Blown fuse Check for a blown fuse (F01) on the control board.
->If a blown fuse is found, check for a short-circuiting or earth fault
of the actuator.
(5) CT3 failure Replace the inverter if this problem is detected after the compres-
sor has gone into operation.
(6) Control board failure Replace the control board if none of the above is causing the
problem.