Mitsubishi Electric Apricot MS Series, Руководство пользователя

Страница: 71 / 108

OWNER’S HANDBOOK
M o t h e r b o a r d F e a t u r e s & U p g r a d e s : P e n t i u m I I s y s t e m s 6 / 5
Processor multiplier (J5 to J8) CPU
bus 66MHz
The details below are given for the clock speeds of
processors known at the time of writing. Higher speed
and overdrive processors may become available, in
which case consult your supplier for further
information.
J5 J6 J7 J8 Ratio CPU speed
I I I O 3 200
O I I O 3.5 233
I I O I 4 266
O I O I 4.5 300
I=jumper fitted, O=No jumper
Audio DSP (J9)
If you need to disable the PCI audio accelerator
(DSP) move jumper J9 from pins 1-2 (EN) to pins 2-
3 (DIS).
Audio disabling (J10)
The on-board audio system can be disabled by
removing jumper J10 from pins 1-2 (EN) to pins 2-3
(DIS). Disabling the audio system frees the interrupt
and DMA channel used by that system (normally
IRQ5, IRQ11, DMA0 and DMA1).
BIOS upgrade and reprogram (J12, J2)
These jumpers should not normally be changed
except by a service engineer or at the direction of a
service engineer.
CMOS is cleared by moving the jumper J12 to the 2-
3 (CLR) position for a few moments while the system
is turned off and the power cord removed, then
returning it to the 1-2 (NOR) position. It
must be
returned to normal before the power is reconnected.
BIOS reprogramming requires special software.