MITSUBISHI ELECTRIC ENGINEERING TSD-FT1519-MN, Руководство пользователя

Страница: 30 / 48

Connection &
Adjustments
6
4. Connections
Connecting the Cables
Before connecting the signal cable, please turn off the power to this device, your computer and peripheral devices.
It is recommended to connect directly with the computer without the USB hub, etc. when connecting USB.
Fix the cables surely with each fixed screws.
Connecting the power cord
Do not use with power voltages other than it indicated. It causes the fire and the electrical shock.
Before connecting the signal cable, please turn off the power to this device, your computer and peripheral
devices.A dedicated power cable is not provided with this device.
Use a 0.75mm
2
power cable or thicker.
Remove the insulating plate secured with a screw from the top of the power supply connector prior to connection.
In the interests of safety, secure the insulating plate again with the screw after connection.
Connect the input power cable to the terminal block on the rear side of the touch panel monitor.
FG GND 24V
Earth
GND
24V
−
＋
2 N G
Insulating plate
24V DC
power supply
1 3 4 2
DVI-D Mini D-Sub
15pin
USB
type B
D-Sub
9pin
RS-232C
Serial Port
DVI output
VGA
output
USB
Computer
DVI
input
USB
USB Port
VGA
input
RS232C
Touch communication
cable is connected to
only 3 or 4.
Video signal cable is
connected to only 1
or 2.
1: Video signal cable (mini-D-Sub 15pin)
2: Video signal cable (DVI-D) 3: Touch communication cable (USB type B)
4: Touch communication cable (D-Sub 9pin)
When connecting the
USB cable,
secure the
touch communication
cable with the cable
clamper and screw
provided to prevent the
connector from being
disconnected.