801 LSV 8 Ton Electric Logsplitter
14
Original Instructions Version August 19
Damaged electrical connection cable
The insulation on electrical connection cables is often damaged.
This may have the following causes:
• Passage points, where connection cables are passed through windows or doors.
• Kinks where the connection cable has been improperly fastened or routed.
• Places where the connection cables have been cut due to being driven over.
• Insulation damage due to being ripped out of the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage regularly. Make sure that the connection cable does not hang on the
power network during the inspection.
Electrical connection cables must comply with the applicable VDE and DIN provisions. Only use connection
cables with the marking „H07RN“.
The printing of the type designation on the connection cable is mandatory.
For single-phase AC motors, we recommend a fuse rating of 16A (C) or 16A (K) for machines with a high
starting current (starting from 3000 watts)!
AC motor 230 V/ 50 Hz
Mains voltage 230 Volt / 50 Hz.
The mains connection and the extension cable have to be three-core cables = P + N + SL. - (1/N/PE).
Extension cables must have a minimum cross-section of 1.5 mm². Mains fuse protection is 16 A maximum.
11. Cleaning
Attention!
Pull out the power plug before carrying out any cleaning work on the equipment.
We recommend that you clean the equipment immediately after you use it.
Clean the equipment regularly with a damp cloth and some soft soap. Do not use cleaning agents or solvents;
these may be aggressive to the plastic parts in the equipment. Ensure that no water can get into the
interior of the equipment.
