801 LSV 8 Ton Electric Logsplitter
13
Original Instructions Version August 19
Stroke limit for short logs
Lower splitting knife position about 10 cm above table.
• Move splitting knife to the desired position
• Release one operating arm
• Switch motor off
• Release the second operating arm
• Undo the star grip screw (10a)
• Push the stroke set rod (8) to the top until it is
stopped by the spring
• Tighten the star grip screw (10a) again.
• Switch motor on
• Check upper position
Switching on and off (12)
Press the green button for switching on.
Press the red button for switching off.
Note: Check the function of the ON/OFF unit before every use by switching on and off once.
Restarting safety in case of current interruption (no-volt release).
In case of current failure, inadvertent pulling of the plug, or a defective fuse, the machine is switched off
automatically.
For switching on again, press anew the green button of the switch unit.
Splitting
• Place the log on the table, hold it with both handles, press the handles down. As soon as the splitting
knife enters the wood, push the handles down and to the outside at the same time. This prevents the
wood from putting pressure on the holder plates.
• Only split straight cut logs.
• Split the logs in vertical position.
• Never split in horizontal position or across.
• Wear protective gloves when splitting.
End of work
• Move the splitting knife to the lower position.
• Release one operating arm.
• Switch the machine off and pull the power plug.
• Close the venting cap.
• Observe the general maintenance instructions.
Electrical connection
The electrical motor installed is connected and ready for operation. The connection complies with the
applicable VDE and DIN provisions.
The customer‘s mains connection as well as the extension
cable used must also comply with these regulations.
8
10a
