field. To skip to the next drive letter, press [N]. If you accept the values, the
parameters will appear listed beside the drive letter on the screen. The process
then proceeds to the next drive letter. Pressing [N] to skip rather than accept a
set of parameters causes the program to enter zeros after that drive letter.
When auto-detection is completed, the program automatically enters all entries
you accepted on the field for that drive in the “Standard CMOS Setup” menu.
NOTE:
If you are auto-detecting a hard disk that supports the LBA
mode, the program will display all possible modes supported by the hard
disk including
Normal
,
LBA
(Logical Block Addressing), and
Large
modes. Choose the line that lists
LBA
for an LBA drive. Do not select
Large
or
Normal
.
NOTE:
To support LBA or Large mode of hard disks, the hard disk
service routine uses INT 13h . If you are running under an operating
system which replaces INT 13h, the system may fail to access a hard
disk with LBA/Large mode selected.
Exiting Setup
To exit the SETUP program, you can choose “Save & Exit Setup” or “Exit
Without Saving” from the main menu.
After finished with your settings, you must save and exit SETUP so that the
settings can take effect.
5-22
The SETUP Program
