Appendix A
Software Drivers and Utilities
This appendix describes the drivers and utilities used in your system. The
drivers and utilities allow you to take advantage of special features of your
system.
NOTE:
The driver and utility CD may have been updated after this
manual was published. If your CD is different from that described in this
appendix, refer to the README files on the CD. These files contain the
latest information from the software supplier.
Installation Instructions for Windows 95
IDE/USB Bus Driver
The IDE/USB bus driver is provided for Windows 95 (OSR2 and later versions)
to recognize the PIIX4E controller chip used by your system. This chip controls
the functions such as USB, IDE, and Power Management of your system. You
must install the driver to use the capabilities of PIIX4E.
To install IDE/USB bus driver for Windows 95:
1. Run the
USBSUPP.EXE
program from Windows 95 950B (OSR2.1) or 950C
(OSR2.5) CD. Contact the Microsoft dealer if you can not find this program.
2. Insert the driver and utility CD into the CD-ROM drive.
3. Run the
SETUP.EXE
program in the \CHIPSET directory on the CD to set up
the new hardware.
4. Use the default settings to complete the setup when Windows 95 is re-
started.
To verify if the installation is completed successfully, follow these steps:
1. Select “Control Panel”, “System”, and then “Device Manager”.
2. Click on “View devices by type” button.
Software Drivers and Utilities
A-1
