Swap Floppy Drive
This feature allows you to exchange the drive names of the two floppy disk
drives, if installed. Make sure that
Drive A
and
Drive B
item in the Standard
CMOS Setup menu are updated accordingly.
The available options are
Enabled
and
Disabled.
Boot Up Floppy Seek
This item sets if the system will verify the floppy disk drive type during POST.
The available options are
Enabled
and
Disabled
. Select
Disabled
to bypass the
floppy disk drive check and thus speed up POST.
Boot Up Numlock Status
This item sets if the Num Lock key will be automatically activated after system
startup.
The available options are
On
and
Off
.
Boot Up System Speed
This item sets the default system speed
-
the normal operating speed at power
up.
The available options are:
Options
Descriptions
High
The CPU operates at full speed.
Low
The CPU operates at the speed of the AT bus. You may need to
select this option for using some low-speed expansion card or old
software.
Gate A20 Option
This item uses the fast gate A20 line to access any memory above 1MB. Setting
this item to make the access faster than the normal method.
The available options are
Fast
and
Normal.
Typematic Rate Setting
This item sets if the typematic rate is to be used. When disabled, continually
holding down a key on your keyboard will generate only one instance. In other
words, the BIOS will only report that the key is down. When the typematic rate is
enabled, the BIOS will report as before, but it will then wait a moment, and, if the
key is still down, it will begin the report that the key has been depressed
5-8
The SETUP Program
