MiTAC 15EX-TA, Руководство по эксплуатации и руководство по устранению неисправностей

Страница: 14 / 73

LCD MONITOR 15EX
LCD MONITOR 15EX
-
-
TA MAINTENANCE
TA MAINTENANCE
13
<Operation>
LIGHT LEVEL
item: The number is response the LIGHT LEVEL value anytime. (Number range: 0~31)
Press “select key” will go to next item.
MAX: 800LUX
item: This will set the maximum value for program. (HEX Number)
Put the 800Lux light to sensor board, and press “menu key” to start set value procedure. (When
it’s running, the number is flashing until the procedure end.)
Press “menu key” will run this procedure again.
Press “select key” will go to next item.
MID: 400LUX
item: This will set the middle value for program. (HEX Number)
Put the 400Lux light to sensor board, and press “menu key” to start set value procedure. (When
it’s running the number is flashing until the procedure end.)
Press “menu key” will run this procedure again.
Press “select key” will go to next item.
MIN: 0 LUX
item: This will set the minimum value for program. (HEX Number)
Put the 0Lux light to sensor board, and press “menu key” to start set value procedure. (When it’s
running the number is flashing until the procedure end.)
Press “menu key” will run this procedure again.
Press “select key” will go to next item.
LOAD DEFAULT
item: This will load default value for program.
Press “menu key” to execute this procedure.
msg*
item: This will show the Warning or Error.
When (MAX-MID)<2048 it will show “Warning: small range”. If it’s happen please check the sensor
board output frequency range at 0Lux, 400Lux and 800Lux, and restart set MAX, MID, MIN value again.
When (MAX-MID)<1750 it will show “ERROR”. If it’s happen please analysis the sensor board.
EXIT: Press “Power Key”, then it will exit the “FACTORY USED ONLY” and “All Reset” will be done.
Note: Normal case the value relation is MAX>MID>MIN, and (MAX-MID) should over 2048.