Mirapoint RazorSafe 700, Руководство по оборудованию

Страница: 94 / 98

Jumpers and Connectors
88
B
Figure 37 Standard PCIe Expansion-Card Riser 2 Components
Disabling a Forgotten Password
The appliance's software security features include a system password and a setup.
The password jumper enables these password features or disables them and clears
any password(s) currently in use.
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
To disable a forgotten password:
1. Power off the appliance, including any attached peripherals, and disconnect the
appliance from the electrical outlet.
2.
Open the appliance. See Opening the Appliance on page 30.
3. Move the password jumper plug to the disabled position (pins 4 and 6).
4. See Figure 33 on page 84 to locate the password jumper (labeled PWRD_EN)
on the system-board.
5.
Close the appliance. See Closing the Appliance on page 30.
6.
Reconnect your appliance and peripherals to their electrical outlets, and power
on the appliance.
The existing passwords are not disabled (erased) until the appliance boots with
the password jumper plug in the disabled position. However, before you assign
a new appliance and/or setup password, you must reset the jumper plug to the
enabled position.
5 release button
1 chassis intrusion switch 2 screw
3 slot 3 PCIe x8 link (full-height,
24.13-cm [9.5-in] length) 4 slot 4 PCIe x8 link (full-height,
24.13-cm [9.5-in] length)
5 pin collars (2) 6 card edge connector
3
4
1
2
6
5