Mirapoint RazorSafe 700, Руководство по оборудованию

Страница: 63 / 98

Processors
57
9.
Install the cooling shroud. See Installing the Cooling Shroud on page 37.
10.
Close the appliance. See Closing the Appliance on page 30.
11. Reconnect your appliance and peripherals to their electrical outlets, and power
on the appliance.
Processors
Removing a Processor
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
To remove a processor:
1.
Prior to upgrading your appliance, download the latest appliance BIOS version
to install the update on your appliance. For use, contact your Mirapoint
representative.
2. Power off the appliance, including any attached peripherals, and disconnect the
appliance from the electrical outlet.
3.
Open the appliance. See Opening the Appliance on page 30.
4. Remove the cooling shroud. See Removing the Cooling Shroud on page 36.
w
The heat sink and processor are hot to the touch for some time after the
appliance has been powered down. Allow the heat sink and processor to cool
before handling them.
c
Never remove the heat sink from a processor unless you intend to remove the
processor. The heat sink is necessary to maintain proper thermal conditions.
5.
Release one of the heat-sink release levers ( Figure 28 on page 58).
6. Wait 30 seconds for the heat sink to loosen from the processor.
7. Release the other heat-sink release lever.
8.
Gently lift the heat sink off of the processor and set the heat sink aside upside
down (thermal grease side facing up).