Miranda XVP-801i, Инструкция по установке и эксплуатации

Страница: 36 / 39

GUIDE TO INSTALLATION AND OPERATION
32 | XVP-801i
Figure 3.18 Front card edge user interface
Status LEDs:
IN1, IN2 Green indicates the selected input. When IN2 flashes yellow,
indicates that the
Fail Over mode is active, and has switch over to
input 2 (see page 8 Input Fail Over sub-section )
ERR Error detected on video input (red)
REF Valid reference signal detected (green). When flashing, there is a
line format mismatch between the reference input and the HD/SD
input or output
AUDIO IN DETECTED Indicates which audio groups are present in the SDI input (green)
TEST Test signal selected at the output (yellow)
Alphanumeric display Displays the input format in normal mode
3.4 XVP-801i Menu
Menu level LEV1 LEV2 LEV3 LEV4 LEV5
Configuration load CONF LOAD [USR1, USR2, USR3, USR4]
Configuration save SAVE [USR1, USR2, USR3, USR4]
Input Selection ISEL INP [1, 2]
Gpi priority PRIO [OFF, ON]
Failover emergency mode FAIL [OFF, ON]
Failover emergency delay FDLY [0, 15]
Input aspect ratio ASPT 4 :3 [PURE, LB12, LB25]
16 :9 [PURE, ANAM, SP12, SP25]
4 :3 item is available only in SD mode
ANAM item is available only in HD
format. So it does not appear in SD
format
Procamp parameters PROC Y [-800, …, 0, 1, …, 800] no unit
Cb [-800, …, 0, 1, …, 800] no unit
Cr [-800, …, 0, 1, …, 800] no unit
SAT [-800, …, 0, 1, …, 800] no unit
ALL [-800, …, 0, 1, …, 800] no unit
BLAK [-100, …, 0, 1, …, 100] no unit
HUE [-180, …, 0, 1, …, 180] unit = DEG