17
Backplate
Backplate Nut
RAC Elbow
RAC Shroud
Important!
Ensure the recessed
pipework is vertical and the arrow on
the backplate is in an upright position.
4.
Make sure that the foam seal abuts
the finished wall surface, place the
backplate against the foam seal and
using the two screws supplied fix the
backplate to the wall.
5.
Fit the compression olive and the
backplate nut over the copper pipe
and tighten the nut into position. Flats
are provided on the backplate nut to
take a 24mm A/F spanner.
6.
Ensure the 'O' seal is fitted to the
backplate nut. Ensure the clips on
the elbow are fully engaged with the
backplate
7.
Locate the RAC shroud over the RAC
elbow. Carefully push the shroud until
it engages with the lugs on the
backplate.
8.
To complete the installation fit the
slide bar, handset and soap dish.
Follow the installation instructions in
"Mira Logic ev - Exposed Variable
Shower Fittings"
(Page 10).
'O' Seal
15 mm Copper
Pipe
Foam Seal
Backplate
Backplate
Nut
Compression
Olive