Minox ACX 300, Инструкция по эксплуатации

Страница: 26 / 33

LED status display
Photo capture button
Video capture button
Main button
50 51
Using the remote control
The remote control, similar to a wristwatch, shows 3 status display LEDs
in the top view. The photo capture button is at the top, the video capture
button is in the middle, and the main switch is at the bottom.
The LEDs display the following functions:
Left LED: The LED lights blue if WiFi is connected.
Middle LED: The LED lights blue if connected to the camera. The LED lights
red when the battery is charged. If the camera’s battery is charged while
the camera is running, the LED lights purple.
Right LED: The LED flashes green when the camera is recording. A light
signal is emitted whenever a photo is taken or video recorded.
Photo capture button: The camera takes a photo when you press the capture
button.
Video capture button: The camera begins to record video when the capture
button is pressed. It ends when the button is pressed again.
Main button: The camera turns off when this button is pressed continuously
for 4 seconds.
Connecting the camera and the remote control
You can connect the camera and remote control in just a few steps:
1. Make sure that the camera and remote control are fully charged.
2. Press the remote control’s photo and video capture buttons simultane-
ously and keep them pressed while turning on the camera.
3. Release both capture buttons when the camera has started up.
4. The connection is established when the middle LED on the remote control
lights blue.