Minolta PI4700E, Руководство пользователя, Страница: 97 / 426

4 Setup tab
4-14 Pi4700e
Pr
op
er
tie
s
S
e
tti
ng
s
Chap
ter
4
✎
Notes for (1)
If Staple is set, printed pages are fed out into the Elevator Tray.
The stapling position is either the top left corner or the top right corner
depending upon the direction of the paper and the printing direction.
If the capacity of Mailbin Finisher, Single-staple Finisher, Multi-staple
Finisher or Folding Finisher is exceeded, the stapling operation may
be canceled. Refer to the User Manual of the machine.
If you print a document consisting of pages of different sizes in the
same printing job, stapling may be canceled.
Take care when printing a document consisting of pages facing differ-
ent directions, since the stapling position will be determined by the di-
rection of the first page.
You cannot set certain sizes or kinds of paper. For details, refer to the
User Manual of the machine.
Only Center Staple can be set with Booklet.
✎
Tip for (1)
You can check the stapling positions using the icons in the dialog box.
✎
Notes for (2)
Number of punch holes can be specified only when Multi-staple Fin-
isher is installed.
Punch Holes is not displayed for Metric area.
You cannot punch certain sizes of paper. Also, you may be unable to
punch the paper at certain positions. For details, refer to the User Man-
ual of the machine.
If you select Long Edge in the manual bypass take-up mode, the paper
may sometimes fail to be punched.
Punch and OHP interleaving cannot be set simultaneously.
Punch and Booklet cannot be set simultaneously.