Minolta PI4700E, Руководство пользователя, Страница: 264 / 426

Using the utility software 8
Pi4700e 8-33
Netw
or
k
I
n
ter
fa
c
e
Car
d
Chap
ter
8
✎
Note
Use colons to delimit each octet in the MAC address as shown on the
Network Card’s status page.
5
Reset the Digital Copier by powering it down and then back up again.
The above step outputs a fixed-period BOOTP request.
6
Click the Go button on the BOOTP dialog.
7
Wait for about five minutes until the Network Card resets.
8
Select
Verify
from the
Admin
menu. You should get a response that in-
dicates whether or not your unit is active.
❍
If you get a message stating that the unit is active, you should be
able to ping to the Network Card using the steps below.
❍
If you get a message stating that the unit is not active, check
whether TCP/IP is enabled on the status page.
9
Display the MS-DOS prompt and type the following:
ping <Network Card IP address>
10
Repeat step 8 until a response is received. Configuration is complete
when a response starting with the words
Reply from... is returned.
11
Quit BOOTP.
✎
Note
You cannot use BOOTP to assign an IP address if the Network Card
has already been assigned an IP address by ATIP.