MINOLTA-QMS MAGICOLOR 6110, Руководство по установке

Страница: 45 / 52

Regulatory Compliance
45
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. How-
ever, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or tele-
vision reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
„
Reorient or relocate the receiving antenna.
„
Increase the separation between the equipment and receiver.
„
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
„
Consult the dealer or an experienced radio/TV technician for help.
5 "
A shielded cable is required to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
commercial environment. This equipment generates, uses, and can radiate
radio frequency energy, and. if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interfer-
ence at his/her own expense.
Attention
Any modifications or changes to this product not expressly approved in
writing by the manufacturer responsible for compliance to Federal
Regulations could void the user's authority to operate this product
within the Laws and Regulations of the Federal Communications
Commission.
EN 55022
This is a Class A device for Ethernet 10BaseT/100BaseTX and the optional
ETRAX 100 board. This is a Class B device for serial and parallel interfaces.