9 | minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
k. Move to the other side of the Ulterra to install the
remaining hardware. Ensure that the Mounting Holes
in the Base Extrusion are aligned with the Mounting
Holes in the Top Plate.
l.
Take three each of the Stainless Steel Screws,
Clipped Washers and Nylock Nuts. Insert the Screws
from the bottom up, through the Top Plate and into
the Base Extrusion. Place a Clipped Washer on each
Screw, positioned so that the flat side of the Washer
faces toward the Base Extrusion. Secure each Screw
with a Nylock Nut and tighten with a 7/16” Box End or
Open End Wrench. Make sure all hardware is secure.
Mounting Holes
Mounting Holes
Mounting
Mounting
Hole
Hole
Top
Top
Plate
Plate
Stainless Steel Screw
Stainless Steel Screw
Clipped
Clipped
Washer
Washer
Nylock
Nylock
Nut
Nut
CAUTION
Use extra care to avoid pinching and damaging the
sensor wires that run alongside the Base Extrusion
when installing and tightening the mounting hardware.
6
6k
6l
m. At this point in the installation, the Motor should
be secured to the Top Plate and can now be
reassembled. Slide the Extension Damper back
in place on the Damper Pins. This should be done
so the shaft on the Damper is pointing inboard.
Reinstall the two 5/16” E-clips.
E-clips
E-clips
Extension
Extension
Damper
Damper
Damper Pins
Damper Pins
7
n. Replace the Right Sideplate.
o. Replace the Left Sideplate.
p. Reinstall the four Sideplate Screws using a #3
Phillips Screwdriver.
Left Sideplate
Left Sideplate
Screw
Screw
Screw
Screw
Screw
Screw
Right Sideplate
Right Sideplate
Screw
Screw
8
8n
8o
Inboard
Inboard
