7 | minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
Installing the Top Plate to an Ulterra
Power Cables
Power Cables
1
Deployed
Deployed
Stowed
Stowed
a. Place the mount on an elevated, level surface such
as a workbench or the tailgate of a pickup. The
motor should be in the stowed position.
NOTICE:
This installation requires the use of hardware
that was included with the Ulterra motor. Six Clipped
Washers (Part #2201725) from the Ulterra Bag
Assembly (Part #2994917) will be needed.
NOTICE:
A motor may weigh up to 65lbs. Minn Kota
recommends having a second person help with
the installation.
WARNING
Make sure that the Power Cables from the battery are
disconnected or that the breaker, if equipped, is “off.”
b. With a #3 Screwdriver, remove the four Sideplate
Screws. Two of these screws will be located on each
side of the mount.
c. Remove the Right Sideplate to access the
Mounting Slots.
d. Remove the Left Sideplate to access the
Mounting Holes.
Left
Left
Sideplate
Sideplate
Right
Right
Sideplate
Sideplate
2c
2d
e. Under the Left Sideplate, the Extension Damper
obstructs access to the front-left Mounting Hole.
f.
Using a small Screwdriver, remove the two 5/16"
E-clips holding the Extension Damper in place. Once
the E-clips are removed, slide the Extension Damper
off the Damper Pins to expose the left rear Mounting
Hole. Set the two E-clips and Extension Damper in
a safe place so they are not misplaced. They will be
reassembled later in the installation.
E-clips
E-clips
Extension
Extension
Damper
Damper
Damper Pins
Damper Pins
Extension
Extension
Damper
Damper
E-clip
E-clip
E-clip
E-clip
Mounting Hole
Mounting Hole
3e
3f
3
2
WARNING
Illustrations are for reference only. Do not deploy the motor until
it is fully mounted to the boat. Deploying your motor before it is
mounted to the boat may cause injury.