5 | minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
e. Place the flat side of the Top Plate (Assembly #C)
against the bottom of the Base Extrusion. Align the
Mounting Holes in the Top Plate with the Mounting
Holes in the Base Extrusion that were exposed when
the sideplates were removed. Make sure that the
Cam Lever points inboard. The appearance of the
Base Extrusion may vary depending on motor type.
#4 x 6
#10 x 6
#6 x 6
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
Top Plate
Top Plate
Cam Lever
Cam Lever
Mounting
Mounting
Holes
Holes
Mounting
Mounting
Holes
Holes
Base Extrusion
Base Extrusion
Stainless
Stainless
Steel Screw
Steel Screw
Nylock Nuts
Nylock Nuts
Flat Washer
Flat Washer
Outboard
Outboard
Inboard
Inboard
g. With the Top Plate secured to the Base Extrusion,
replace the Right Sideplate.
h. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
i.
Replace the four sideplate screws using a #3 Phillips
Screwdriver. Two of these screws will be used on
each side of the mount.
Right Sideplate
Right Sideplate
Left Sideplate
Left Sideplate
Base Extrusion
Base Extrusion
3
4
4g
4h
ITEM(S) NEEDED
Sideplate Screw
Sideplate Screw
4i
f.
Use six each of the Stainless Steel Screws (Item #4),
Flat Washers (Item #10) and Nylock Nuts (Item #6)
to secure the Top Plate to the Base Extrusion. The
Screws should pass from the bottom up, through the
Top Plate and into the Base Extrusion. Place a Flat
Washer on each Screw on top of the Base Extrusion,
and then secure with the Nylock Nuts. Tighten the
Nylock Nuts with a 7/16” Box End or Open End
Wrench. Make sure all hardware is secure.
#C x 1
