MiniTrencher GeoRipper GR16, Инструкция по эксплуатации и безопасности

Страница: 15 / 20

USING THE MINITRENCHER EZ KART™
WARNING!
Electric shock can be fatal regardless of whether you are using the GeoRipper® minitrencher
manually or with the MiniTrencher EZ Kart™ system. Remember to check the location of all
underground services, especially electric cables, prior to digging.
CALL 811 BEFORE YOU DIG
Refer to instructions supplied with EZ Kart™ for assembly.
Lay the control handle on the ground so it is engaged with the rear/lowest detent position on
the axle. This position will keep the axle receiver mount in a level position.
Position the EZ Kart tongue, located at the bottom of the GeoRipper® adapter, into the axle
receiver mount (Fig. L.) Lock in place by engaging the latching slide bolt through the receiver
mount. Slide bolt handle rotate to lock into place on EZ Kart™ axle.
Pull control handle out of detent position and reposition in first/upper detent position.
The detents allow the operator to control the angle of the digging blade and chain. This allows
for greater depth consistency.
BEFORE STARTING POWERHEAD
Position throttle control assembly onto throttle handle of powerhead so that EZ Kart™ throttle
latch engages the powerhead throttle trigger. Secure in place by wrapping the attached Velcro
strap around powerhead handle.
With engine switched off, check for smooth throttle operation by operating remote throttle
lever and adjust throttle cables as required using the in-line cable adjuster on the throttle cable.
Make sure the engine will return to idle after operating remote throttle.
Place tow strap around lower back (at or below belt line) and adjust length for comfortable
operation. Proceed with trenching. (Refer to powerhead Owner’s manual and page ## of this
Manual for correct starting procedure.)
Fig. K
10