AN-48-003 Rev. H (Jun 09, 2022) This document and its contents are the property of Mini-Circuits ECO-013719 Page 18 of 44
3.1.4
If multiple PWR power sensors are
connected to the computer via USB, the
initial screen will show a list of S/N for connected units. You can select a single unit, or
multiple units you wish to start with – each opening in its own window. The program can
handle up to 24 units connected
simultaneously
.
Figure 3.1.4:
Unit selection screen
# Name
Description
1
Number of
sensors
Shows total number of power sensors detected
2
Sensor List
List, by serial number of all sensors detected
3
O.K
Proceed with the sensors selected
4
Select All
Marks all sensors listed
5
Deselect all
Cancels selection of all sensors listed
6
Freq
Enter the frequency to be tested for best results. If multiple units are selected
all will use the compensation factor suitable for this frequency.
7
Compact View Open selected power sensors in compact view
8
Recording
Open data recording window to set data recording for one or more of the
sensors
9
Cancel
Exit the program
See
section 3.11
for detailed description of operating with multiple units.
3.1.5
If no PWR power sensors are
connected to the computer via USB or there is
a problem with the USB connection selecting USB will cause the following alert will pop-up.
Click OK and check the USB connections before clicking the ‘reset connection’ button.
Figure 3.1.5:
No USB unit found
