Page 12
sessions, the PAL36 with CES will scroll through the “B” sessions, and
then the “C” sessions. When the desired session lights up, press SEL. If
you want a session from group “B” or “C”, wait for the “A” group to
finish and the “B” group will scan, followed by group “C”. Pressing the
INT button will allow you to scan through the sessions faster. If LIB2
sessions are being selected, the LIB light will be on. Once a session has
been selected, the session number will flash a few times. Then the eyeset
lights and headphone volume will start low and gradually increase over
ten seconds until the levels reach the preset settings of intensity and
volume (Soft On). This allows you time to put on the eyesets and
headphones. During the remainder of the session, the session light (eg.
A1, B4) will flash briefly every few seconds to remind you of the session
number selected. Every eighth flash will show the battery power level (1
to 6). As the session ends, the eyeset lights and volume will fade out (Soft
Off
TM
). If no buttons are pressed, the PAL36 with CES will go into
standby in two minutes. The green PWR light will remain dimly lit
reminding you to turn the PAL36 with CES off.
Selecting Heartbeat
All of the DAVID PAL36 with CES sessions (except Sound Sync
Sessions) begin with the heartbeat on. To turn to heartbeat off, press and
hold the SEL button for approximately one second. To turn the heartbeat
back on, press and hold the SEL button again for approximately one
second.
Selecting Pulsed Tone/Binaural Beats/Chime
All of the DAVID PAL36 with CES sessions (except Sound Sync
Sessions) begin with the pulsed tone on. Press the SEL button once to
turn the pulsed tone off and select Binaural Beats. Press the SEL button
again to turn Binaural Beats off and select Chime. Press SEL once more
to turn all tones off. Press SEL again to turn the pulse tones back on.
Adjusting Volume
Note: The volume button (VOL) is raised to guide you to locate button
with eyes closed during sessions.
To increase the volume of the tones
through the headphones, press and hold the VOL button. To decrease the
volume, release VOL button and press and hold again. Or you may press
short single steps for small adjustments in the volume. The indicator
lights 1 to 6 will show the volume level.
