MIMAKI UJF-3042FX, Руководство по эксплуатации, Страница: 41 / 146

Drawing an image from source data
2-11
2
Basic Operations
When [! WORK High] is displayed
When [! WORK High] is displayed on the screen and the drawing operation
stops during drawing, restart drawing with the procedures below:
1
Press the key.
• The screen returns to LOCAL.
2
Check the media setting status, and press the key.
• The machine restarts drawing.
• If you do not wish to restart drawing, press the
key to interrupt drawing.
( P.2-10 “Interruption of drawing”)
If you open the cover during drawing
I
f you open the cover or press the emergency stop switch during drawing, the
warning message is displayed on the screen.
1
Press the key.
2
Press the or key to select “CONTINUE” or “CANCEL” of drawing.
• When you select “CANCEL”, the machine starts initialization.
• When you select “CONTINUE”, the right screen is displayed.
When you continue drawing, press the key.
When you stop drawing, press the key.
• During drawing, the sensor always monitors the media height. When the gap check function ( P.3-7)
is set to “OFF”, if the sensor detects the media, the drawing operation is interrupted automatically, and [!
WORK High] is displayed on the screen.
• When you continue drawing, image missing may occur depending on the timing of the cover opened.
• When you open the cover when the drawing operation is not
performed, the right screen is displayed. In this case, press the
key
E R R O R 5 0 5
! WO R K H i g h
< L O C A L >
ENTER
REMOTE
DATACLEAR
R e s e t a s w i t c h
P R I N T I N G P A U S E
C O N T I N U E <
> C A N C E L
ENTER
R e s u m e P r i n t
P R E S S < E N T > K E Y
ENTER
END
( R E S E T SW I T C H )
P R E S S < E N T > K E Y
ENTER