- 2.12 -
13. Set an empty paper tube to the take-up device.
14. Close the front cover and push the [ENTER]
key.
The width of the medium is detected.
Press the [ ] jog key to feed the medium up to the paper
tube position of the take-up device.
15. Fix the medium to the empty paper tube using
an adhesive tape.
• Check that there is no slack or
wrinkle, caused by uneven tension, on
the roll medium in the range between
the roll holder and the platen.
While pulling the roll medium from
side to side evenly, clamp the lever.
• If the roll medium used is wide, the
edges of the paper may get loose
from the platen during plotting. Use
the media plate to hold down the
edges of the medium. This prevents
the medium from being stained with
the ink by getting loose from the
platen.
• When using a thick medium, remove the media
plate from the medium before plotting.
Содержание JV22-130
