MIMAKI GP-604D, Руководство по эксплуатации

Страница: 38 / 134

- 2.8 -
Checking and solving nozzle clogging
Before printing on media (T-shirt), print a test pattern on thermal paper.
Perform test plotting to check whether there is nozzle clogging or other plotting failures.
If the test pattern shows any sign of abnormal conditions, carry out the cleaning function.
• If the plotting failure cannot be recovered even after repeatedly performed the
cleaning operation, clean the wiper and ink cap. page 3.4
• Perform test print on a thermal paper.
As discharge liquid is colorless, normal media(paper,T-shirt) can not be recognized.
After turning the heater power of the table on, print using the attached thermal
paper.
Other media(paper, T-shirt) except thermal paper can not judge properly.
When thermal paper is used up, purchase thermal paper for FAX on the market.
• The origin needs resetting to print test. Pattern at the time the plate is set.
page 4.14
Print the test pattern
STEPS:
1. Reverts to the LOCAL mode.
Press the [REMOTE] key to put the device back into the
LOCAL mode.
2. Check that the heater power is ON.
3. Press the [TEST] key.
4. Press the [ENTER] key.
The device plots the test pattern.
After plotting, the menu reverts to the LOCAL mode.
5. Check the test patterns.
If a failure occurs, proceed with next page.
If the test pattern is normally plotted, complete the operation.
Normal pattern
Abnormal pattern
Nozzle is dirty Clogged with ink
< LOCAL >
width : 610 mm
TEST DRAW
< ENT >
∗ ∗ TEST DRAW ∗ ∗
< LOCAL >
width : 610 mm
TEST