MIMAKI GP-604D, Руководство по эксплуатации

Страница: 12 / 134

- viii -
CAUTION
Ink cartridges
• If the ink cartridge is moved from
a cold place to a warm place,
leave it in the room temperature
for three hours or more before
using it.
• Open the ink cartridge just
before installing it in the plotter.
If it is opened and left for an
extended period of time, normal
printing performance of the
plotter may not be ensured.
• Make sure to store ink cartridges
in a cold and dark place.
• Be sure to thoroughly consume
the ink in the ink cartridge, once
it is opened, within three months.
If an extended period of time has
passed away after opening the
cartridge tank, printing quality
would be poor.
• You cannot use any other ink
type than the exclusive one.
• Never refill the ink cartridge with
ink.
• Neither pound the ink cartridge
nor shake it violently so as to
prevent leakage of ink.
• Do not touch or stain the
contacts of the ink cartridge as
doing so may cause damage to
the print circuit board.
Heater
• Do not spill liquid on the table
as this may cause failure of the
heater or ignition.
• Do not touch the table heater
with bare hand while it is hot as
this may cause burn.
• When moving the device, wait
unit the heater temperature
drops.
As a criterion, wait at least 30
minutes since you turn off the
power of the heater.
The device can be moved within
the same floor without steps.
When moving it to a different
place, contact representative of
your dealer.
Warning labels
• This device is adhered with a
warning label at two locations.
Be sure understand firmly the
warnings given on the labels. In
the case where any of the
warning label has become so
soiled that the warning message
is illegible or has come off,
purchase a new one from your
local distributor or our office.
Refer to Appendix for the label
adhering locations.