MIMAKI CG-130FXII, Руководство по эксплуатации

Страница: 135 / 152

– 4.7 –
Warning message
The messages given below appear under the remote mode.
They do not indicate errors but require an appropriate action.
CUT1 * REMOTE * The device is in the remote
mode.
A press on the [REMOTE] key
will cause the device to enter
the local mode.
CUT1 * 128KB * This indicates the amount of
data received.
When starting cutting, the
amount of data will decrease in
increments of 1 KB.
** OFFSCALE ** The data on cutting exceeds
the effective cutting area.
Use a larger sheet, decrease
the amount of data or execute
the divided cutting function.
** NO SHEET ** Move the clamp lever without
attaching a sheet.
Move the clamp lever after
attaching a sheet.
** VIEW ** The device has received the
not-ready-mode signal (NR;)
from the host computer to
enter the local mode.
Execute required operations
such as the sheet detection or
the establishment of an origin.
Then, press the [REMOTE] key
to make the device to enter the
remote mode.
** DIGITIZE ** The device has received the
digitization command (DP;)
from the host computer to
enter the digitization mode.
Move the pen to a desired
location, where necessary, and
press the [REMOTE] key.
To reset the digitization mode,
execute the data clear using the
[DATA CLEAR] key.
Message Cause Remedy
* 1/10 COPY * The device is engaged in the
plural sheets cutting. The
number indicates the “1st
sheet is being cut/Estab-
lished number of sheets to
be cut.”
Upon completion of the plural
sheets cutting, the device will
automatically enter the remote
mode.
** END COPY ** The device terminates copy-
ing when one copy is fin-
ished since the data received
contains the origin updating
command (ZT;, !PG;).
The plural sheets cutting is
disabled.