– 3.67 –
Command priority setting [PRIORITY]
This function is used to specify the setting that is given priority in terms of the following commands;
either the setting established on the device or that established on the host computer is given priority.
The following is the settable commands.
Command name
Command
Pen selection command
SP:
Pen lowering speed setting command
VS:
Pen lifting speed setting command
ZA:
Acceleration setting command
AS:
Pen pressure setting command
FS:, ZF:
Blade-tip correction setting command
ZO:
Setting value
PANEL
: The device operates using the setting established on its operation panel.
HOST
: The device operates using the setting established by the command setting function
of the host computer.
The maximum size of the response [DISTANCE]
Set the maximum size of the response in meter unit.
This function is effective in the MGL-I c1 used.
Setting value
1 to 51 m
•
The set value not affect on the actual available cut area
In case the detected sheet size is smaller than the [DISTANCE], the de-
tected size is to be the response value.
Содержание CG-130FXII
