Sterylis BASIC MANUAL
| 15
During active front panel lock mode, press and hold the UV-C and FILT buttons in the OPERATION TIME section for 3
seconds simultaneously.
6.5
Changing the configuration parameters
To change the configuration parameters, press and hold the OK button in the "TIMER" section in the standby mode. Then
enter the appropriate code to change the parameters.
Entering the access code:
The 4-digit code entered is shown on the display under AUTOMATIC MODE. The + and - buttons change the value by 1
active digit. An active number is the one that flashes at a high frequency, inactive numbers light up constantly. The OK
button changes the active digit to the next one on the right. After entering the correct code, confirm it by long pressing the
START button. If the code is incorrectly entered, the code HHHH will be displayed and a short beep will occur. In this case,
the code must be re-entered.
You can change the following parameters:
Parameter
code
Description
Min value
Max value
Default value
C150
Date setting - day of the month
1
31
15
C151
Date setting - month
1
12
7
C152
Date setting - year
2020
2120
2020
C200
FIRMWARE revision (read only)
-
-
FW_REV
The individual parameters are changed using the + and - buttons in the AUTOMATIC MODE section. The code of the
selected parameter is displayed in the AUTOMATIC MODE section. The current value of the selected parameter is
displayed in the OPERATION TIME section.
To change the value of the selected parameter, operate the + and - buttons in
the OPERATION TIME section. The selection of the active digit is made by means of the RESET button. To confirm the
value of the selected configuration parameter, press and hold the OK button in the AUTOMATIC MODE section. The
selected value will be confirmed by a short beep and all active displays will flash.
To return to the standby mode, press and hold the OK button in the TIMER section.
6.6 Working time counters
The device is equipped with the operating time counters listed in the table below. The user has the possibility to read the
indications of these counters and reset them.
To view or reset the counters, press and hold the OK button in the TIMER section in the device standby mode. Then enter
the appropriate code to change the parameters.
Entering the access code:
The 4-digit code entered is shown on the display under AUTOMATIC MODE. The + and - buttons change the value by 1
active digit. An active number is the one that flashes at a high frequency, inactive numbers light up constantly. The OK
button changes the active digit to the next one on the right. After entering the correct code, confirm it by long pressing the
START button. If the code is incorrectly entered, the code HHHH will be displayed and a short beep will occur. In this case,
the code must be re-entered.
You can interfere with the following counters:
Parameter code
Description
d102
UV-C lamp service interval timer [s]
d105
Fan service interval timer [s]
d120
Air filter interval timer [s]
d201
Active electricity consumption meter [kWh]
