Miller Robotic Interface II, Руководство пользователя

Страница: 51 / 78

OM-172 324 Page 45
10-22. Arc Failure Shutdown
1 Arc Fail Display
This feature can be turned on and
off. If the feature is On, a time can be
selected after which the weld is
aborted.
J o g I P M
R o b o t
>A r c F a i l
M o n i t o r
T i m e r
>O f f
T i m e
0 . 0
T i m e r
>O n
T i m e
0 . 7
Increase
1
Press
Mode Select
Access
Setup
Display
Figure 10-22. Arc Fail Display
10-23. Arc Voltage Error Selection
1 Monitor Display
Provides a means to enable/dis-
able the arc voltage error feature
and to set an acceptable range of
deviation from set arc voltage or arc
length (trim) before the error will ac-
tuate.
When this feature is off, arc voltage
or arc length variations will not
cause an error or shut the unit
down.
When this feature is on and a range
of deviation is set (
±
0.1 – 9.9 volts
from desired weld voltage), arc volt-
age or arc length variations outside
of the range for a period of time
longer than that set by the Arc Error
timer, causes either the error relay
to energize or the unit to shut down
depending on the Arc Start/Volt
Sense shutdown error setting.
R o b o t
A r c
F a i l
>M o n i t o r
S o f t w a r e
Ar c V o l t s
>O n
2 . 0 V o l t s
1 . 0 S e c
A r c V o l t s
>O f f
1
Press
Mode Select
Increase
Access
Setup
Display
When a system reset is done, Monitor is set to Off.
Figure 10-23. Monitor Display
10-24. Software Version Number
1 Example Version Number Dis-
play
When talking with service person-
nel, this number may be required.
(Check actual unit display for num-
ber.) The factory keeps this number
on file with the serial number of the
unit.
1
R o b o t
A r c
F a i l
M o n i t o r
>S o f t w a r e
Ve r s i o n
#1 2 3 4 5 6 Z
Press
Mode Select
Access
Setup
Display
Figure 10-24. Version Number Display