Miller Robotic Interface II, Руководство пользователя

Страница: 46 / 78

OM-172 324 Page 40
10-12. Selecting Units For Wire Feed Speed And Motor Type
Increase
1 Wire Feed Display
The displayed unit of wire speed
(IPM or MPM) can be changed
along with the wire feed motor type
(Standard, Low Speed, or High
Speed).
A r c S t a r t
A r c
T i m e
>W i r e f e e d
W i r e t y p e
Di s p l a y
> I P M
Mo t o r
T y p e
S t a n d a r d
Di s p l a y
>MP M
Mo t o r
T y p e
S t a n d a r d
1
Di s p l a y
I P M
Mo t o r T y p e
>S t a n d a r d
Di s p l a y
I P M
Mo t o r T y p e
>L o w S p d
Di s p l a y
I P M
Mo t o r T y p e
>H i g h S p d
Parameter
Select
Increase Increase Decrease
Press
Mode Select
Access
Setup
Display
Figure 10-12. Wire Feed Display
10-13. Selecting Wire Type
If wire type is changed, perform a memory reset (see Section 10-15) immediately
after selecting wire type to bring up the correct welding programs.
NOTE
1 Wire Type Display
Select soft wire when using alumi-
num wire in the wire feeder. Select
hard wire when using any other kind
of wire.
W i r e T y p e
I n F e e d e r
>H a r d w i r e
Increase
1
Press
Mode Select
Access
Setup
Display
A r c T i m e
W i r e f e e d
>W i r e t y p e
D i s p l a y
W i r e T y p e
I n F e e d e r
>S o f t w i r e
Figure 10-13. Wire Type Display