Miller Big Blue 450X Duo CST, Руководство пользователя

Страница: 29 / 64

Complete Parts List available at www.MillerWelds.com
OM-247969 Page 25
NOTICE − Lead acid batteries discharge
when stored in any temperature. Units that
are stored should have the battery
recharged every three months and before
being put into service. To preserve opti-
mum battery performance and life,
recharge battery in storage when the
open − circuit voltage drops to 12.4 volts
DC when measured across the battery
terminals.
!
Connect negative ( − ) cable last.
NOTICE − Wait two minutes after engine
shutdown before disconnecting battery or
engine controller may be damaged.
Battery is accessed through the side door.
Connect battery, negative cable last.
Close side door.
Do not allow the battery cables to
touch opposing terminals. When connect-
ing the battery cables attach the positive
(+) cable to the positive (+) battery termin-
al first, followed by negative ( − ) cable to
negative ( − ) battery terminal.
Never start the engine when the
cables are loose or poorly connected to
the battery terminals.
Never disconnect the battery while
the engine is running.
Never use a quick battery charger to
start the engine.
Do not charge battery with Engine
Control switch On.
Always disconnect the negative ( − )
battery cable before charging battery.
5-4. Connecting The Battery
1/2 in.
−
+
Tools Needed:
Conn_Batt2 2014 − 11 / S-0756-C / 161-002
Shown with door
open and rocker
panel removed.
5-5. Engine General Information
Check all engine fluids daily.
Engine must be cold and on a level sur-
face.
Automatic Shutdown System
Automatic shutdown system stops en-
gine if oil pressure is too low or coolant
temperature is too high.
This unit has a low oil pressure shut-
down switch. However, some condi-
tions may cause engine damage be-
fore the engine shuts down. Check oil
level often and do not use the oil pres-
sure shutdown system to monitor oil
level.
Run-In
Follow run-in procedure in engine manu-
al. If unburned fuel and oil collect in ex-
haust pipe during run-in, see Section 11.
NOTICE − Diesel engines in MILLER
equipment are meant to operate optimally
at moderate to rated load. Light or no load
may cause wetstacking or engine dam-
age.
Cold Weather
To improve cold weather starting:
Use Preheat switch (see Section 6-1 ).
Keep battery in good condition. Store
battery in warm area.
Use fuel formulated for cold weather
(diesel fuel can gel in cold weather).
Contact local fuel supplier for fuel in-
formation.
Use correct grade oil for cold weather
(see Section 8-1).
Use engine block heater if applicable
(see Section 6-3).
Gen_engine1 2012 − 04