Miller Electric MIGHT High Power TIG 150, Руководство пользователя

Страница: 12 / 24

3-5. Installing Shoulder Strap, Selecting A Location, And Connecting Input Power
3-6. Selecting Extension Cord (Use Shortest Cord Possible)
V
Do not move or operate unit
where it could tip.
1 Welding Power Source
Shoulder Strap
Install strap as shown.
Use strap to lift unit.
2 Rating Label
Label is located on bottom of
unit. Use rating label to deter-
mine input power needs.
3 Input Power Cord
4 115 or 230 VAC Grounded
Receptacle
The Auto-Line circuitry in
this unit automatically links
the power source to the pri-
mary voltage being applied,
either 115 or 230 VAC.
An individual branch circuit
capable of carrying 30 amperes
and protected by fuses or circuit
breaker is recommended.
Recommended fuse or circuit
breaker size is 30 amperes.
V
Unit is supplied with a
115 VAC plug. For 230
VAC operation, have a
qualified person obtain a
proper plug that meets all
applicable codes,
and
install the plug according
to the manufacturer's
instructions.
Connect input power plug to a
proper receptacle.
V
Special installation may
be required where gaso-
line or volatile liquids are
present – see NEC Article
511 or CEC Section 20.
Ref. 803 351-C / 220 875-A
Front Panel
To Rear Panel
Airflow Distance
Requirements
Single Phase AC
Input Voltage
Conductor Size mm*
22mm2 13mm2 8mm2 5.5mm2 3.5mm2
Maximum Allowable Cord Length meter
115 49 33 22 14 9
230 144 98 66 45 27
*Conductor size is based on maximum 3% voltage drop
OM-221 022 Page 8