HAZARD CATAGORIES AND SPECIAL SYMBOL
Read all instruction carefully and check the device before installing or servicing it. The following safety alert
symbol may appear throughout this manual or on the device to warn of any potential hazards or to call for
attention.
PLEASE NOTE
The power meter should be installed, operated, serviced and maintained only by qualified personnel. No
responsibility is assumed by the manufacturer for any consequences arising out of the use of this material.
DISCLAIMER
Mikro shall not be liable for errors contained herein including any incidental and/or consequential damages
arising from the use of this material. Mikro also reserves the right to vary the product from that described in this
material without prior notice.
COPYRIGHT
The licensed software contained in the product is proprietary software owned by Mikro or its third party suppliers
and shall be used solely in connection with the product.
BEFORE YOU BEGIN
•
Apply appropriate personal protective equipment and follow safe electrical work practices.
•
NEVER work alone.
•
Turn off all power supplying the power meter and the equipment in which it is installed before working
on it.
•
Always use a properly rated voltage sensing device to confirm that all power is off.
•
Before closing all covers and doors, carefully inspect the work area for tools and objects that may have
been left inside the equipment.
•
NEVER bypass external fusing.
•
NEVER open circuit a CT; use the shorting block to short circuit the leads of the CT before removing
the connection from the power meter.
•
Before performing hi-pot testing on any equipment in which the power meter is installed, disconnect all
input and output wires to the power meter. High voltage testing may damage electronic components
contained in the power meter.
•
The power meter should be installed in a suitable electrical enclosure.
Failure to follow this instruction may result in serious injury
