Check of V-belt
(Fig. 30)
At every 200 hours, remove the belt cover
(top) to check the tension of the V-belt. The
flexibility of the belt should be about 10 mm
when pushed strongly with your finger at the
mid-point between the axes. When the
V-belt is loose, the engine power is not
transmitted well, resulting in poor compact-
ing force and shortening the life of the
V-belt.
Changing the V-belt
Removing the V-belt
Remove the top and bottom belt covers. Put
a wrench (13mm) on the tightening bolt of
the vibrator pulley (lower side). Put a piece
of cloth at the center of the left side of the
V-belt, and pull the belt strongly towards
you. While pulling, turn the wrench clock-
wise, then remove the V-belt.
Installing the V-belt
Set the V-belt on the lower side of the vibra-
tor pulley. Push the V-belt to the left side of
the upper clutch. Similar to removing the
V-belt, turn the wrench clockwise to install.
Stop the engine when inspecting or chang-
ing the V belt.
Be careful not to have your hand or clothes
get caught between the V belt and the
clutch. Always wear work gloves.
1
2
●
●
●
●
19
11.5 Checking/Changing The V-belt
Fig.29
1
2
Lock
Dust exhaust
Fig.27
Engine air cleaner
Dust pot
Latch
Dust exhaust
Fig.28
Clutch
V-belt
Vibration pulley
Fig.30
HATZ (1B20)
Cyclone Cleaner
Always clean Dust Pot. Clogged Dust Pot
leads to reduce cyclone effect with easy
wear of Cleaner Element.
How to clean Dust Pot
Latch off to remove Dust Pot. (Fig.28)
Clean Dust Pot inside with water and neu-
tral detergent.
Latch up securely to return Dust Pot to Air
Cleaner.(Fig. 29)
●
i)
ii)
iii)
CAUTION
！
Be careful to avoid pinched fingers.
CAUTION
！
Do not use organic solvent like paint thin-
ner, which may cause damage or deforma-
tion of Dust Pot.
CAUTION
！
