Mikado VBAR, Руководство пользователя

Страница: 23 / 34

23
Connect the sensor wire to the VBar unit. As shown on the label, the
yellow wire faces toward the outside.
To avoid the sensor picking up any vibrations from lose wires, secure
the wires at approx. 2 cm from the sensor using a cable strap.
Prior to your maiden flight, you need to re-check all travel directions
on your transmitter and on the VBar set-up menu.
During power-on, which initializes the VBar, do not move sticks or the
helicopter. After you see a brief twitch of the swash plate, you must
check both positive and negative Collective pitch, Elevator up and
down, and Aileron right and left.
You must also check the sensors are moving the swash plate in the
right direction.
Elevator
To do so, move the heli nose-down. The swash has to tilt to the back.
Move the heli tail-down. The swash has to tilt to the front.
The compensation movements of the swash plate are rather small,
so take a close look. You can also check the servo arms.
Aileron
Now roll the heli to the left. The swash plate has to tilt to the right.
Roll the heli to the right, and the swash plate moves to the left.
Tail
And lastly, the tail: the compensation always occurs against the actual
movement.
8. Checking Travel Directions