10
Adjusting the height of the grab handle
The grab handle is designed exclusively to provide a safe and
secure standing position throughout the duration of the EMS
training session (
Chapter 11.5 “Training” on page 92
).
Risk of injury from using the grab handle in an inappropriate
manner!
– Use the grab handle only for the purpose of holding on to
while performing EMS training described in (
– Never use the grab handle as a pull-up bar.
– Do not use the grab handle as a support for performing
push-ups or other types of gymnastic exercises.
Using the grab handle for pull-ups or otherwise subjecting it
to a large portion of your body weight (e.g. performing push-
ups) involves the risk of the grab handle breaking off. Apart
from material damage to the device, this may result in injuries
from a fall.
Personnel:
n
Athlete/Patient
The height of the grab handle can be individually adjusted. Pro-
ceed as follows to adjust the handle height:
1.
Loosen the two clamping levers (Fig. 55/2), but do not
unscrew them all the way. To do so, pull the clamping levers
forwards and move them so that the clamping lever can be
released counterclockwise.
ð
The height of the grab handle can be adjusted when the
clamping lever is released.
2.
Adjust the height of the grab handle (Fig. 55/1) in the upper
third of the guide rail (Fig. 55/3).
3.
Tighten the clamping lever clockwise.
The handle must not be loose after tightening and must sit firmly.
Check to make sure that the screw connection is tight prior to
every training session.
Using the handle properly
L
CAUTION
Adjusting the handle height
Fig. 55: Adjusting the handle height
Adjusting the height of the grab handle
2021-07-28
miha-bodytec II EMS training device
84
Содержание BODYTEC II
Страница 1: ...miha bodytec II Operating instructions US...
