10
Warning
Read warning notice
and instruction manual
carefully prior to initial
operation and save the
information for later use
Permissible installation
Mains connection
Connect the machine to the mains supply that it is
designed for (see type plate (U
1
) on the back of the
machine).
Connection of shielding gas
Connect the gas hoses to a gas supply with 2-6 bar
pressure reduction.
Important!
In order to avoid destruction
of plugs and cables, good
electric contact is required when
connecting earth cables and
welding hoses to the machine.
Connection of welding hose
Configuration
MIGATRONIC disclaims all responsibility for damaged
cables and other damage related to welding with
undersized welding torches and welding cables
measured by welding specifications e.g. in relation to
permissible load.
Worn-out electrical equipment must be
separately collected and handed over for
reuse according to EU-directive 2012/19/EU.
Dispose of the product according to local
standards and regulations.
www.migatronic.com/goto/weee
Connection of old Migatronic TIG machines
For connection of TIG ERGO welding hoses to old
generations of TIG machines, the following extra
parts are required:
TIG-machines
produced before 1989
with 3/8”-connection
TIG-machines
produced after 1989
with dinse plug
MTA-MDA
MDU
TDE
LTE
THD
MTE
All models with 6 pole plug.
Connect the welding
hose directly and connect
the plug by means of an
adaptor.
Parts required:
25420103 Nipple
43620011 Lock nut
gas
43715008 Clip
80300116 7/6 pole adaptor
Cut the wire between pins 2
and 4 in the adaptor
Parts required:
80300116 7/6 pole adaptor
The adaptor is included if
the welding hose is ordered
as a 6 pole model.
7/6 pole adaptor
order no.: 80300116
Connection and start-up
All manuals and user guides at all-guides.com
