Maintenance and repair
© MIG·O·MAT GmbH
BA_Lötstar_EN_Vers. 07.2016
37
8.1.4
Cleaning of the dryer glass
Carefully read and observe the safety instructions in
section 8.1. (e.g. protection goggles and gloves) before you
carry out this maintenance work!
During operation, condensation water and entrained electrolyte
are separated in the dryer glass (
see illustration 8.1.3.C.
). If
there is more than 1 cm of condensate in the glass, remove the
condensate and rinse the glass with hot water subsequently.
For the disposal of electrolyte
see section 9.2.
1. Switch off the gas production at the
on/off
key
I/O
at the
operating panel.
2. Unscrew the fastening ring by turning it to the left (
see
illustration 8.1.3.D
.).
3. Remove the dryer glass. Move the complete top part
sideways to facilitate removal of the dryer glass.
4. Clean the glass as described above.
5. Remount the dryer glass by screwing the fastening ring
back to the right (
see illustration 8.1.3.E
.).
8.1.5
Exchange of the filter cartridge in the dryer glass
During operation of the unit, the gas flowing through the unit is
dried in the filter cartridge (
see illustration 8.1.3.C.
). After a
certain period of time the filter cartridge is saturated with liquid
and must be exchanged. We recommend to exchange the filter
cartridge approx. once per year depending on the operating
hours.
Carefully read and observe the safety instructions in
section 8.1. (e.g. protection goggles and gloves) before you
carry out this maintenance work!
1. Switch off the gas production at the
on/off
key
I/O
at the
operating panel.
2. Unscrew the fastening ring of the dryer glass by turning it to
the left (
see illustration 8.1.3.D
.).
3. Remove the dryer glass. Move the complete top part
sideways to facilitate removal of the dryer glass.
4. Unscrew the filter cartridge, remove and replace it.
5. Remount the dryer glass by screwing the fastening ring
back to the right (
see illustration 8.1.3.E
.).
WARNING!
How to proceed
WARNING!
How to proceed
