Miele K 34673 iD, Инструкции по эксплуатации и монтажу

Страница: 23 / 92

The correct temperature
23
Temperature display
In normal operation the temperature
display shows the
average, current
temperature in the refrigerator .
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature in the display.
Setting the temperature
 Use the two sensors underneath the
display to set the temperature.
By touching the sensor
– the temperature will get colder,
– the temperature will get warmer.
The temperature being set will flash in
the display.
The following information shows in the
display while the sensors are being
touched:
– Touching a sensor once: the last
temperature selected flashes.
– Each subsequent touch of the
sensor: adjusts the temperature
shown in 1°C steps.
– Leaving a finger on the sensor
changes the temperature continu-
ously.
Approximately 5 seconds after the last
time a sensor has been touched, the
current temperature inside the appli-
ance is automatically shown.
Or

Touch the OK sensor to confirm your
selection.
If you have adjusted the temperature,
wait for approx. 6 hours if the appli-
ance is not very full and for approx.
24 hours if the appliance is full
before
checking the temperature display, as it
will take this long for the appliance to
give an accurate reading.

If, after this time, the temperature is
still too high or too low, you will need
to adjust it again.
Temperature range
The temperature can be adjusted from
3 °C to 9 °C.