Cleaning and care
139
At the end of the Self Clean program
When the duration remaining reaches
0:00 h, a message will appear in the
display to tell you that the door is
unlocking.
When the door lock has been
deactivated:
–
Program Finished
appears.
– The buzzer will sound if it has been
turned on (see “Settings – Volume –
Buzzer tones”).
Turn the oven off.
The buzzer will stop and the symbols in
the display will go out.
Danger of burning!
Wait until the oven has cooled down
before removing any residual soiling
left in the oven compartment after
the Self Clean program.
Wipe any residues (e.g., ash) left
behind after the Self Clean program
out of the oven compartment and off
of any accessories. The amount of
ash will vary depending on how dirty
the oven was.
Most soiling can be easily removed
using a clean, soft sponge and a mild
solution of warm water and liquid dish
soap.
Depending on how dirty the oven was
prior to cleaning, there may be a
visible layer of soiling across the inner
glass pane on the door. This should
be removed using the scouring side of
a dish sponge, a glass scraper, or with
a stainless steel scrubbing pad and
liquid dish soap.
After the Self Clean program pull the
FlexiClips with wire rack apart several
times.
Please note:
– There is a fiberglass seal around the
oven cavity which seals the inside of
the glass oven door and can be
damaged by rubbing and scouring. If
possible, refrain from cleaning this
gasket.
– The FlexiClips with wire rack may
appear discolored or a lighter color in
places after they have been cleaned.
This will not affect the function of the
runners in any way.
– Spilled fruit juices may cause lasting
discoloration of enameled surfaces.
This discoloration is permanent but
will not affect the properties of the
enamel. Do not attempt to remove
these marks.
