Midtronics MCC-070, Инструкция по эксплуатации

Страница: 8 / 24

MCC-070 Controlled Charger
Midtronics BV Hoofdveste 6-8 3992 DG Houten www.midtronics.com
8
General Safety Precautions
8 Removing the Battery
8.1 If it is necessary to remove the battery from the vehicle or
equipment, always remove the grounded terminal from
the battery first.
Risk of explosive gases.
Prevent flames and sparks. Provide adequate ventilation
during charging.
Risk of explosive gases.
Make sure all vehicle loads are OFF to prevent a
possible arc.
8.2 Check the polarity of battery posts.
8.3 Connect the POSITIVE (RED) charger clamp to the POSI-
TIVE (POS., P, +) post of battery.
8.4 Position yourself and the free end of cable as far away from
the battery as possible—do not face the battery when
making the final connection—then connect the NEGATIVE
(BLACK) charger clamp to the free end of the cable.
8.5 When disconnecting the charger, always do so in the reverse
sequence of the connecting procedure; break the first con-
nection while staying as far away from the battery as practical.
9 Maintenance & Storage
Follow these guidelines to protect the charger and test cables
from damage and premature wear:
9.1 The grease, dirt, and sulfation that build up on battery ter-
minals are highly corrosive and can damage the clamps
over time. Before connecting the clamps, ensure accurate
test readings and protect the clamps by cleaning the bat-
tery case and terminals using a wire brush and a mixture
of water and baking soda.
9.2 Periodically clean the clamps using a mixture of baking soda
and water, or a mild hand-soap, and a small bristle brush.
9.3 Clean the battery terminals. If stud adapters are required,
fasten them with the proper tool. Do not use the battery
clamps to tighten adapters.
9.4 Never remove the clamps from a battery to abort an ac-
tive charging session. Always press the red STOP button
before removing the clamps.
9.5 Do not leave the clamps laying in battery acid.
Locking Power Cord
Always use the red tab on the side of the power cord connector
to release/remove it from the charger’s power socket.
Pull Up To
Release
Storage
Always store the charger in safe, dry location and maintain it in
perfect condition.
When not in use, always keep the charger on the stabilizing base
that came with the unit. Make sure it is secured using the two (2)
included Phillips-head screw and the appropriate threaded holes.
Wireless Safety
The operation of this equipment is subject to the following
two conditions.
1. This equipment or device may not cause harmful interfer-
ence.
2. This equipment or device must accept any interference.
Including interference that may cause undesired opera-
tion.