3
midstreamlighting.com call +44 (0) 207 584 8310
MODUS R 1000 INSTALLATION GUIDANCE
2
Contents
Prior to starting the installation, check the equipment list
to be sure of using the correct tools (mounting screw(s)
and nut(s) are not supplied).
24 mm standard wrench for M16 screws
30 mm standard wrench for M20 screws
#8 allen key
Powered drill-screwdriver with adjustable
torque (clutch)
Torx T25 insert bit for powered screwdriver (to be
used with M5 screws)
Torx T25 manual screwdriver
Torx T30 insert bit for powered screwdriver (to be
used with M6 screws)
Torx T30 manual screwdriver
Monkey pliers
Electrician scissors for wires
Ph2 screwdriver
Slotted manual screwdriver for connector’s
screws (blade dimensions: 3.5(w) x 0.6(t)mm)
Wire stripping pliers
DO NOT USE PERCUSSION DRILLS!
Equipment list
Wear adequate working gloves, safety shoes and
hard hats to protect yourself from falling material
Never energize the lamp if wiring operation are not
completed
H&S check
1. General notes
Section
PAGE
1 General notes
3
2 Safety instructions
4
3 Contents
5
4 Bracket mounting and aiming
6
5
Visor mounting
7
6
Electrical connection
7
7
Floodlight connection
8
7a Floodlight connection with connector
9
7b Floodlight connection without connector
14
8
Power supply connection
17
9
Control connection Dali
19
10 Control connection 0-10V
20
11 Cabinet driver
21
This user manual contains important information on safe operation of the Luminaire.
Read and follow all safety notes and all instructions. Save this manual for future reference.
Make sure that it is available to all persons using this device.
All wiring should be done by a licensed electrician in accordance with state codes, local codes, and National Electric
Code (NEC) standards or International Electrotechnical Commission (IEC) standards.
The Luminaire is suitable for wet locations.
This luminaire must only be replaced by the manufacturer, by its service staff or by qualified personnel.
The luminaire is suitable for outdoor use
IP66:
The product is protected against powerful water jets.
DO
Store the luminaire with care, avoiding placing the lenses on the ground, which may scratch or damage them
Keep the luminaire in the original packaging when storing to avoid damage
When handling the Luminaire, wear industrial safety gloves and safety boots
Operate on circuitry when the electrical power supply is disconnected
DO NOT
Apply mains voltage through the control system cable. This will damage the luminaire and it will no longer be
covered by warranty
Unnecessarily remove the luminaire from the box
Leave the LED luminaire switched on when resting on the ground with optics facing down
Place the luminaire with the lens on the ground, dirty or metal surfaces
Clean the lenses with any industrial detergent. Use a water-soaked cloth if needed
12 Driver/floodlight pairing
22
13 Electrical specifications
22
14 Weight and Windage
22
15 Dimensions
23
