34
C. OUTSIDE TOP EXHAUST (Vertical Duct)
C1. ATTACH THE MOUNTING PLATE TO THE WALL
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach the plate to a wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the holes designated to go into drywall
?!!$ %
INSTALLATION OVERVIEW
C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. Adapting Microwave Blower for Outside Top Exhaust
C4. Check Damper Operation
C5. Mount Microwave Oven
C6. Adjust Exhaust Adaptor
C7. Connect Ductwork
IMPORTANT NOTES:
• Make sure the screws for the blower motor and blower plate are securely tightened when
they are reinstalled. This will help to prevent excessive vibration.
• Make sure the motor wiring has been properly routed and secured, and that the wires are
not pinched.
3/8" TO EDGE
NOTE: IT IS VERY I
MPORTANT TO
READ AND FOLLOW
THE DIRECTIONS
IN THE INSTALLATION INSTRU
CTIONS
BEFORE PROCEEDING
WITH THIS
REAR WALL TEMPL
ATE.
This Rear Wall Templa
te serves to position th
e bottom
mounting plate and to l
ocate the horizontal exhau
st
outlet.
1. Use a level to check
that the template is po
sitioned
accurately.
2. Locate and mark at lea
st one stud on the left o
r
right side of the cen
terline.
It is important to use a
t least one wood
screw mounted firmly i
n a stud to support the w
eight
of the microwave. Mar
k two additional, evenly
spaced
locations for the suppl
ied toggle bolts.
3. Drill holes in the ma
rked locations. Where t
here is
a stud, drill a 3/16" h
ole for wood screws. F
or holes
that do not line up w
ith a stud, drill 5/8" hol
es for
toggle bolts.
DO NOT INSTALL TH
E MOUNTING PLATE
AT THIS TIME.
4. Remove the template
from the rear wall.
5. Review the Installation
Instruction book for you
r
installation situation
.
Locate and mark holes
to align with holes in t
he
mounting plate.
IMPORTANT:
LOCATE AT LEAST
ONE STUD ON EIT
HER SIDE OF
THE CENTERLINE.
MARK THE LOCATION
FOR 2 ADDITIONAL, EV
ENLY
SPACED TOGGLE BO
LTS IN THE MOUNTING
PLATE
AREA.
Locate and mark hole
s to align with holes in t
he
mounting plate.
IMPORTANT:
LOCATE AT LEAST O
NE STUD ON EITHER SI
DE OF
THE CENTERLINE.
MARK THE LOCATIO
N FOR 2 ADDITION
AL, EVENLY
SPACED TOGGLE BOL
TS IN THE MOUNTING
PLATE
AREA.
Trim the rear wall tem
plate along the dott
ed line.
Trim the rear wall tem
plate along the dot
ted line.
12"
4"
Darle vuelta a la hoja
para consultar la
versión en Español.
