29
NOTE: Before tightening toggle bolts and wood screw, make sure the bottom of the
mounting plate touch the bottom of the cabinet when pushed flush against the wall and
that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate
and the wall.
4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts.
You need to drill holes for the top support screws and a hole large enough for the power
cord to fit through.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.
B4. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
B5. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST
1. Remove and save screw that holds blower motor to microwave.
2. Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust
the blower unit.
Back of
Microwave
Blower Motor
Blower Motor
Screw
End B
End A
Forward
Openings Facing
Before: Fan Blade
